I have a Powerlinc V2 USB and a Switchlinc V2, and I'm having trouble getting Shion to control the Switchlinc.

I've followed along with this page:
http://www.audacious-software.com/products/shion/getting-started.html
but I'm still having problems.

The address printed on my Switchlinc is: 0C.8E.C4, which I typed into the Shion "address" field without the periods.

However, I never gain control of the device. AFTER my failure, I installed a trial verion of Indigo. That worked right away, so I'm confident my hardware and wiring is correct.

The directions in the box that came with the Switchlinc mentions holding down buttons, etc. I didn't bother with any of this because it wasn't mentioned in your directions.

I'm aware of the conflict with the Indigo over-ride extension in /System/Library/Extensions. I tried Shion before I ever installed Indigo, and I removed the kext once I confirmed that the hardware was working with Indigo, so I'm confident that isn't the problem.

If you have any troubleshooting hints, I'd appreciate it. If there is any other information I could provide (logs, etc) I'd be happy to.

thanks,
Cedar