Mac OS X | Audio / Video | Editors | Apple Final Cut Express | video capture

Apple Final Cut Express

digital video editing (use software update)

Version: 4.0.1

[ Views: 1076 ]

video capture

Feedback Type: Troubleshooting Report

Contributed by: Sverre 99 Tuesday, June 20 2006 @ 02:09 AM PDT

Product Platform: MacOSX

Used Product For: Less than a month

Recommend Product: YES

With this version of 3.5 of the software it is impossible to capture the video if at the Mac it is connected a Fire Wire disk. The software show the following message "This operation could not be completed as there is no video". If you disconnected the FW disk the software capture regularly the video. It is a very annoyng bug!!!

System Info:PM G5 DP 2.0 GHz 2.5 RAM FW disk LaCie 250 GB

3 of 4 users found this helpful.

Rate this Troubleshooting Report

Was this Troubleshooting Report helpful? Yes | No

Comments

video capture - cthulhu11

It's well-documented that certain camcorders have faulty FireWire implementations that require them to be the only devices on the bus. That's not FCE's fault.

Reply to This

Wednesday, October 15 2008 @ 12:20 PM PDT