nothing happens... - mark_ringenoldus

you din't try to update your firmware to a new one, this is to restore it after you installed the new firmware.

Reply to This

Wednesday, April 05 2006 @ 12:11 PM PDT

nothing happens... - deejemon

Kind of. It's to restore your firmware after you unsuccessfully tried to update it and your Intel Mac is no longer starting up (properly). I suppose it will probably let you downgrade your firmware as well.

Reply to This

Wednesday, April 05 2006 @ 06:36 PM PDT

nothing happens... - scapesuit

The Apple Knowledge Base article says that it can only be used after an interrupted or failed Firmware update attempt. It doesn't sound like you can use it after a successful Firmware update.

Reply to This

Tuesday, September 19 2006 @ 11:51 PM PDT

x86 Firmware Restoration CD 1.1 - biga919

the cd cannot function well at my macbook(firmware:1.4f10),
i power on my macbook and hold down the power button until the LED blinks rapidly followed immediately
by a successive series of blinks, after that i heard a startup beep sound is played and the macbook
straight to Tiger OSX without notice any of (3 quick blinks, 3 slow blinks, 3 quick blinks) as the readme.rtf mentioned.
i apply restoration CD since my current firmware:1.4f10 on my macbook leds the system fan speed in full operation
which creats annoying noise during operation.

am i have any steps missing in the use of firmware restoration CD 1.1 ??

Reply to This

Thursday, September 28 2006 @ 05:58 PM PDT

nothing happens... - ol_pip

Nevertheless, this sounds like one of those CD tool/utility discs to have around in case one picks up an old Mac intel sometime in the future and by chance may need this.

Reply to This

Sunday, January 14 2007 @ 04:54 PM PST