iTunes | D-Vision | Simply won't work

D-Vision

encode DivX 3, DivX 4, XviD with Mencoder

Version: 3.2.2

[ Views: 485 ]

Simply won't work

Feedback Type: Troubleshooting Report

Contributed by: machX.1 Friday, January 07 2005 @ 09:42 PM PST

Product Platform: MacOSX

Used Product For: Less than a month

Neither version 3.0.3 nor 3.0.2 will work past the setup installer for me. Every time, the installer opens after D-Vision gives an alert that not all the components are installed. However, it keeps saying that mencoder is not installed. When I click "install," however, the red "x" denoting something not installed then changes to a green check mark without any disk activity. Lo and behold, D-Vision again refuses to go past the setup assistant again. Anyone have any ideas?

System Info:

Rate this Troubleshooting Report

Was this Troubleshooting Report helpful? Yes | No

Comments

Simply won't work - Rip0ff

No problems here, components install went fine

Reply to This

Saturday, January 08 2005 @ 12:56 AM PST

Here is your fix - Hapsh

Drag the D-Vision installer from the disk image to your HDD before launching it. I had the same problem. It can't copy some files because the disk image is read only. Once it resides on your HDD it will install fine.
Hapsh

Reply to This

Thursday, March 17 2005 @ 08:23 AM PST